Devcon Flexane 80 Putty
Description: Devcon Flexane 80 is a Trowelable urethane for repairing and lining process equipment exposed to wear, impact, abrasion, vibration, and expansion / contraction.
Intended Use: Devcon Flexane 80 is a Repair and rebuild conveyor belts Line process equipment to dampen noise, Line concrete control joints. Cast flexible molds, fixtures, and parts Pot and encapsulate .Product features: Trowels on smoothly Cures to tough, medium-hard rubber (Shore 87A)
Devcon Flexane 80 PuttyChemical Resistance : Chemical resistance is calculated with a 7 day, room temp. cure (30 days immersion) @ 75°F)
1,1,1-Trichloroethane - Poor
Aluminum Sulfate 10% - Very good
Cutting Oil - Fair
Gasoline (Unleaded) - Poor
Hypochloric 10% - Very good
Hydro chloric 36% - Very good
Isopropanol - Poor
Methyl Ethyl Ketone - Poor
Phosphoric 10% - Very good
Potassium Hydroxide 40% - Very good
Sodium Hydroxide 50% - Very good
Sodium Hypo chlorite - Very good
Xylene - poor
TESTS CONDUCTED on Devcon Flexane 80 Putty
Tensile Strength (Urethanes) ASTM D 412
Dielectric Strength, volts/mil ASTM D 149
Cured Hardness Shore D ASTM D 2240
Cure Shrinkage ASTM D 2566
Tear Resistance ASTM D 624
Maximum Elongation ASTM D 412
Surface Preparation for Application of Devcon Flexane 80 Putty :
For METAL SURFACES, thoroughly clean area to be repaired, rebuilt, or lined with Devcon Cleaner Blend 300. Remove any oil, grease, or dirt. Roughen surface by grinding with a coarse wheel or an abrasive disc pad. To prime this surface, apply a coat of Devcon FL-10 Primer and allow to dry tack-free for 15 minutes. If the metal surface requires maximum tear resistance or is exposed to moisture, or if submerged in water, use Devcon® FL-10 and Devcon FL-20 Primer.
For RUBBER SURFACES, thoroughly clean area with an abrasive pad and Devcon Cleaner Blend 300. Surface can also be roughened with a grinding wheel so that it is coarse and free from oil and dirt that may clog the "pores" of the rubber. Wipe or roughen surface with Cleaner Blend 300 until the cloth no longer picks up the color of the rubber. The rubber should appear new or deeper in color. To prime this surface, apply a coat of Devcon® FL-20 Primer and allow to dry tackfree for 15-20 minutes. Use Devcon®FL-40 Primer on "hard-to-bond" rubber surfaces as this gives ultimate peelresistance. Multiple coats may be necessary for porous rubber surfaces.For MAXIMUM ADHESION, sandblast the surface with an angular abrasive until a minimum depth profile of 2-3 mils is met. Blast to near-white finish specification SSPC-SP5 (Steel Structure Painting Council). Prime surface immediately after sandblasting to prevent oxidation.
Industrial epoxy putties,180 degrees centigrade,devcon, epoxy putty, brushable ceramic, titanium putty, steel putty, high temperature, resistant, putty, belzona 1111, belzona brushable ceramic, belozona epoxy putty, devcon, epoxy putty, brushable ceramic, titanium putty, steel putty, high temperature, resistant, putty, devcon flexane 80, rubber putty, rubber rebuilding putty, devcon aluminum putty, online sealing putty, online leak sealant, online leak arrestor, abrassion resistant putty, pin hole sealant, molykote, antisieze, compound,
