Devcon Plastic Steel Putty A
Description: Devcon Plastic Steel Putty is a steel-filled epoxy putty that cures at room temperature and is designed for filling, rebuilding, and bonding metal surfaces.
Intended Use: Devcon Plastic Steel Putty is a Patching and repairing areas where welding or brazing would be undesirable or impossible
Product features: Devcon Plastic Steel Putty Applies easily to vertical surfaces,Machinable to metallic finish, Bonds to aluminum, concrete, and many other metals,Resistant to chemicals and most acids, bases, solvents, and alkalis.
Technical Properties of Devcon Plastic Steel Putty
Color Grey
Mix Ratio by Volume 2.5:1
Mix Ratio by Weight 9:1
% Solids by Volume 100
Pot Life @ 75F 45 min.
Specific Volume 11.9 in.(3)/lb
Cured Shrinkage 0.0006 in./in.
Specific Gravity 2.33 gm/cc
Temperature Resistance Wet: 120 Degrees F; Dry: 250 Degrees F
Coverage/lb 48 sq. in @ 1/4 in
Cured Hardness 85D
Dielectric Strength 30 volts/mil
Dielectric Constant 37.5
Adhesive Tensile Shear 2800 psi
Compressive Strength 8260 psi
Modulus of Elasticity 8.5 x 10(5) psi
Flexural Strength 5600 psi
Coefficient of Thermal Expansion 48 [(in)/(in) x °F)] x 10(-6)
Thermal Conductivity 1.37 [(cal x cm) / (sec. x cm(2) x °C)] x 10 (-3)
Cure Time 16 hrs
Recoat Time 10-12 hrs
Mixed Viscosity Putty
TESTS CONDUCTED
Cure Shrinkage ASTM D 2566
Adhesive Tensile Shear ASTM D 1002
Dielectric Strength, volts/mil ASTM D 149
Dielectric Constant ASTM D 150
Flexural Strength ASTM D 790
Compressive Strength ASTM D 695
Cured Hardness Shore D ASTM D 2240
Coef. of Thermal Expansion ASTM D 696
Thermal Conductivity ASTM C 177
Modulus of Elasticity ASTM D 638
Application Instructions : Spread mixed material on repair area and work firmly into substrate to ensure maximum surface contact. Plastic Steel®
Devcon Putty A fully cures in 16 hours, at which time it can be machined, drilled, or painted.
FOR BRIDGING LARGE GAPS OR HOLES
Place fiberglass sheet, expanded metal, or mechanical fasteners between repair area and Plastic Steel Putty A prior to application.
FOR VERTICAL SURFACE APPLICATIONS
Devcon Plastic Steel Putty A can be troweled up to ¼” thick without sagging.
FOR MAXIMUM PHYSICAL PROPERTIES
Cure at room temperature for 2.5 hours, then heat cure for 4 hours @ 200 Degress F.
FOR ± 70 Degrees F APPLICATIONS
Applying epoxy at temperatures below 70 Degrees F lengthens functional cure and pot life times. Conversely, applying above 70 Degrees F shortens functional cure and pot life.
MACHINING: Allow material to cure for at least 16 hours before machining.
Lathe speed: 150 ft/min
Cut: Dry
Tools: Carbide Top Rake 6° (+/-2°) – Side/Front 8°F (+/-2°)
Polishing: Use 400-650 grit emery paper wet. Material should polish to a 25-50 micro inch.